Building a stitched lapstrake canoe - gluing the seams


Product Design	My Artwork	Living Sustainably
Art Engineering	Levitation Kit	Solar Power	Chevy Volt
About Me	Blog	Solar Heating	Thermal Windows
Contact	Twitter	Solar Hot Water	Solar Mower

home > canoe

Building a Sassafras 14 ft. stitched lapstrake canoe

HOME	1. laying out the planks	2. cutting planks	3. gluing planks	4. rabbeting edges	5. stitching seams	6. shaping hull	7. filleting stems	8. gluing seams
	9. removing stitches	10. filling holes	11. gluing inwhales	12. gluing outwhales	13. glassing outside	14. glassing inside	15. glassing keel	16. decks and seat mounts
	17. installing seats	18. epoxy coat	19. sanding	20. varnishing	21. finishing up	22. launching	storage	BILL OF MATERIALS
	This canoe was built from plans in the book "The Canoe Shop"

July 29, 2007
Gluing the seams -- 2:30 hours

Well, yesterday I made my first mistake. I followed the instructions in the book carefully and mixed up an 8 ounce batch of epoxy and thickened it to ketchup consistency with silica powder. Then using a syringe I started injecting the glue into the seams. In about 5 minutes the syringe became hot and the glue pot started to produce noxious vapors. I took both outside immediately. I realized that I had been using the West System type 205 Fast Hardener. This worked out OK for the stems particularly since the wood flour mixture slowed down the cure rate, but the straight stuff in a larger container sets up too quickly. Today I went out and bought a can of the 206 Slow Hardener (at $33.00) which gives a 20-30 minute working time.

My second mistake was to start again with an 8 ounce mixture. Again in the larger container the epoxy began to set up before I could use it all and I had to take it outside to prevent the fumes from being a problem. So far I have ruined 2 of the 6 syringes that I had bought. From that point on I worked with 2 to 4 ounce batches and re-used the syringe, wiping it off between batches. I used small yogurt containers for mixing.
The application process itself is pretty simple, carefully running down each seam and filling the "V" with epoxy from as deep in as the syringe will go. I over filled a few seams and the glue ran over the edge at the stitches in several places. Fortunately with the slow cure epoxy there's lots of time to wipe the drips off before they harden.

I had a few gaps in my seams that leaked through to the inside of the hull, and again I was able to wipe off the excess before it hardened. This was on the side where I had tightened the stitches, the other side that my friend John had done were all OK - his seams were tighter than mine. There will be a little sanding to do, but not much. Before I filled the top seam, I taped the inside because I could see a tiny sliver of light through the gap in some places. I removed the tape after a few hours before the epoxy fully cured. I may not have needed the tape as there was very little glue at all on the tape, but it made me feel better.

Here are some shots of the seams so far. Tomorrow I remove the stitches and re-fill the seams to level them out.

Here's a movie made from images taken every minute as I glued the seams,
time invested today 2:30:

next >>

visits since 7/29/07
Hit Counter